INSTALLATION INSTRUCTIONS FOR SKY-LINE TAXI-AD CARRIERS

1.  Assemble three frame units to INNER ANGLES "A" and INNER ANGLE with NOSE PIECE
   "B".   See illustration on the position of LOADING ENDS.  Tension springs and drain slots   
     identify the bottom of the frame units.

2.  Insert TOP CORNER PLATES "C" and fasten with self-tapping screws.

3.  Assemble BOTTOM BRACKETS "D" to lower corners of frame.  Be sure to use Shakeproof
     nuts on all machine screws.

4.  Attach MOUNTING FEET as detailed in chart below.  MOUNTING FEET are individually
     numbered.

5.  Position Sky-Line Carrier on roof of car.  Rear sign panel should locate at a suitable
     position from about 1-1/2" to 3" ahead of rear window trim.  MOUNTING FEET should be
     adjusted to level the carrier.  BE SURE THAT MOUNTING FEET DIVIDE  the inner angle of
     the frame equally.  See headliner.

6.  After carrier is located and leveled, mark mounting hole locations.  Use 1/2" drill, being
     careful not to penetrate the headliner.

7.  Drop Wellnuts into the 1/2" holes.  Re-position Sky-Line Carrier over the Wellnuts.  Use
     1/4-20 x 3/4" machine screw to draw up a donut on inner side of roof panel.  See Figure 1
     and 2.